62013 Electronic Temperature Control Device

62013 Electronic Temperature Control Device

It can control the heaters up to 25 amperes between 0 - 100 ⁰C in real time.

For the temperature control requirements of 100 ⁰C or above, a version called 62913, which runs with a K type Thermocouple is produced.

You can see the temperature value on screen and you can run the device either manually or aoutomatically by inputting the start-up and shut-down time.

- When plugged in, it starts running with the default temperature value.

- You can define minimum and maximum limits to the device, you can change the operation temperature within those indicated limits or return to the factory settings.

- For the definitions not to change, the keypad can be locked and unlocked, when required.

- The value of the set temperature can be accessed by the green light.

Dimensions:

Code Width Length Height
62013 187 mm. 173 mm. 87 mm.

Industrial Purpose :

pdf Instruction Manual

In order to benefit the most from the heaters that we manufacture, we had to develop our own temperature control devices.

Therefore, we developed the temperature control devices according to the specific requirements of every work, from small to big.

Joint characteristics of our temperature control devices;

A) The electric feed is on made on the device.

B) They control the temperature with 1 ⁰C degree of precision.

C) Because we programmed them with PIC, we can run the systems in a certain logic.

D) For the temperature measurement under 100 ⁰C , because of the characteristics of the sensor we use, we use shielded sensor wiring between the device and the point of measurement.

E) Some our products are manufactured with the variants, running with K type thermocouples for the temperature control requirements of 100C or above..

F) As the result of the use of semi conductors, you can make millions of switch on-off without the risk of short circuit.

G) The sytems consist of a wide array of devices that can answer to any need.

H) It can measure the temperatures of different points and evaluate the data according to a certain logic.

I) A lower minimum and upper maximum temperature limit is programmed to our heating systems for safety reasons.

J) Any intended temperature is entered as default.

K) It is possible to change the operation temperature. If desired, you can change the default temperature value too.

L) In order to prevent interventions, the devices come with a keypad lock.

M) The specially manufactured devices are made according to the order. They are not covered in this section.

The explanations, instruction manuals and programming animations are detailed on the side.

Temperature Control Devices :   Temperature Control Devices :

 61011 E. T. C. Devices
 61012 E. T. C. Devices
 61013 E. T. C. Devices
 61015 E. T. C. Devices
 61016 E. T. C. Devices
 62012 E. T. C. Devices
 62013 E. T. C. Devices
 62014 E. T. C. Devices
 62018 E. T. C. Devices
 62912 E. T. C. Devices
 62913 E. T. C. Devices
 62914 E. T. C. Devices
 63032 E. T. C. Devices
 63033 E. T. C. Devices
 63034 E. T. C. Devices
 63035 E. T. C. Devices
 63932 E. T. C. Devices
 63083 E. T. C. Devices
 63164 E. T. C. Devices
Copyright (c) 2011 Omak Ltd. Şti.