63083 Electronic Temperature Control Device

63083 Electronic Temperature Control Device

Our 63083 Electronic temperature Control, combined with Electric Board.

63083 Series Devices separately controls 8 different heaters between 0 – 100 degrees.

It can provide output of either 220V AC or 5V DC to 8 different heaters.

The state of all contacts can be displayed from the LED's located in front panel of the device.

The outlets can be controlled manually or automatically in real time.

A variant of 63083 Device with thermocouple sensor is also available.

Humidity Sensors can be integrated to the 63083 Series Devices upon request.

The Device utilizes a specialized software, made by our company.

63083 can be monitored over the digital environment and all of its controls can be done throuhg computer and internet.

Dimensions :

Code Width Length Height
63083 300 mm. 310 mm. 260 mm.

Industrial Purposes :

pdf Instruction Manual

For Mosques:

pdf Instruction Manual

In order to benefit the most from the heaters that we manufacture, we had to develop our own temperature control devices.

Therefore, we developed the temperature control devices according to the specific requirements of every work, from small to big.

Joint characteristics of our temperature control devices;

A) The electric feed is on made on the device.

B) They control the temperature with 1 ⁰C degree of precision.

C) Because we programmed them with PIC, we can run the systems in a certain logic.

D) For the temperature measurement under 100 ⁰C , because of the characteristics of the sensor we use, we use shielded sensor wiring between the device and the point of measurement.

E) Some our products are manufactured with the variants, running with K type thermocouples for the temperature control requirements of 100C or above..

F) As the result of the use of semi conductors, you can make millions of switch on-off without the risk of short circuit.

G) The sytems consist of a wide array of devices that can answer to any need.

H) It can measure the temperatures of different points and evaluate the data according to a certain logic.

I) A lower minimum and upper maximum temperature limit is programmed to our heating systems for safety reasons.

J) Any intended temperature is entered as default.

K) It is possible to change the operation temperature. If desired, you can change the default temperature value too.

L) In order to prevent interventions, the devices come with a keypad lock.

M) The specially manufactured devices are made according to the order. They are not covered in this section.

The explanations, instruction manuals and programming animations are detailed on the side.

Temperature Control Devices :   Temperature Control Devices :

 61011 E. T. C. Devices
 61012 E. T. C. Devices
 61013 E. T. C. Devices
 61015 E. T. C. Devices
 61016 E. T. C. Devices
 62012 E. T. C. Devices
 62013 E. T. C. Devices
 62014 E. T. C. Devices
 62018 E. T. C. Devices
 62912 E. T. C. Devices
 62913 E. T. C. Devices
 62914 E. T. C. Devices
 63032 E. T. C. Devices
 63033 E. T. C. Devices
 63034 E. T. C. Devices
 63035 E. T. C. Devices
 63932 E. T. C. Devices
 63083 E. T. C. Devices
 63164 E. T. C. Devices
Copyright (c) 2011 Omak Ltd. Şti.