Electronic Temperature Control Devices

In order to benefit the most from the heaters that we manufacture, we had to develop our own temperature control devices.

Therefore, we developed the temperature control devices according to the specific requirements of every work, from small to big.

Joint characteristics of our temperature control devices;

A) The electric feed is on made on the device.

B) They control the temperature with 1 ⁰C degree of precision.

C) Because we programmed them with PIC, we can run the systems in a certain logic.

D) For the temperature measurement under 100 ⁰C , because of the characteristics of the sensor we use, we use shielded sensor wiring between the device and the point of measurement.

E) Some our products are manufactured with the variants, running with K type thermocouples for the temperature control requirements of 100C or above..

F) As the result of the use of semi conductors, you can make millions of switch on-off without the risk of short circuit.

G) The sytems consist of a wide array of devices that can answer to any need.

H) It can measure the temperatures of different points and evaluate the data according to a certain logic.

I) A lower minimum and upper maximum temperature limit is programmed to our heating systems for safety reasons.

J) Any intended temperature is entered as default.

K) It is possible to change the operation temperature. If desired, you can change the default temperature value too.

L) In order to prevent interventions, the devices come with a keypad lock.

M) The specially manufactured devices are made according to the order. They are not covered in this section.

The explanations, instruction manuals and programming animations are detailed on the side.

Some our products which we use our Temperature Control Devices:

Barrel Heater
Health Product
Satellite Dish Heater
 Soldering Pot
Copyright (c) 2011 Omak Ltd. Şti.